The Belleville washer pins should move evenly around the entire circumference when tightened. If everything is in order, screw the other three screws into the lamella and gradually tighten them all crosswise in the same way as we pulled them on the flywheel.Using the centering pins and three screws, which we tighten crosswise at a 120 ° angle, make sure the clutch disc remains stable and centered correctly with the centering tool.
HONDA S2000 CLUTCH REPLACEMENT AND FLYWHEEL FORUMS INSTALL
Install the clutch disc into the flywheel using the centering tool.When pressed, the pusher on the clutch roller should move within tolerance and there should be no oil leakage from the gearbox.It is also necessary to check the clutch fork, especially in the places where it is most loaded. We will check the clutch release system for accidental damage to the guide bush or other signs of wear.Check the transmission shaft seal, making sure no oil is leaking from the transmission.Secure the flywheel with a suitable anti-twist device and remove the main fixing screws.They must not be worn and must not show signs of damage. Check the grooves on the transmission input shaft.If the old flywheel is visibly contaminated with oil, the crankshaft oil seal must be replaced. Check the engine crankshaft seal to make sure oil is not contaminating the flywheel.When disassembling-removing the gearbox from the engine However, we will not discuss the disassembly of the gearbox itself, but will jump straight to the point where the gearbox is already separated from the engine. To disassemble the gearbox, we need to disconnect the axle shaft (in some cases it can be removed with the entire loop), disassemble the starter, as well as the battery and its lining, usually disconnect the water cooling pipe and much more. Only with good enough preparation in the area of “freeing up space” does exchange become much easier. To remove the transmission from the engine, there must be sufficient space for servicing.
0 kommentar(er)
